6.3 System / General
Here you can make various settings which affect the device. To do this, click on the menu on
Settings > System / General.
The following options can be changed:
6.3.1 Battery
The battery option allows you to check the remaining battery capacity.
When connected to a power source, Charging is displayed above the capacity meter.
6.3.2 GPS Info
GPS Info indicates the GPS reception signal strength at the current location. Adequate GPS
reception is essential for any navigation.
An info page with information about the existing GPS connection and your current position as
well as the altitude and speed is displayed. The Back button takes you back to the settings
menu.
The colouring provides you with information about the GPS status at a quick glance:
Red: GPS signal is not sufficiently strong to allow positioning. Signals are being received
from fewer than 3 satellites.
Yellow: GPS signal is sufficiently strong to allow positioning, but not sufficiently strong to
allow the current elevation to be determined. Signals are being received from 3 satellites.
Green: A high-quality GPS signal is being received that allows your elevation to be
determined. Signals are being received from at least 4 satellites.
6.3.3 Brightness
Here you can set the brightness of the screen.
The brightness settings have a great influence on the power consumption of your navigation
device. To save power in battery mode, turn down the brightness level.
In addition, you can select whether the screen should automatically be dimmed when the
battery is weak in order to save power.
Confirm your setting by tapping on Ok.
6.3.4 Volume
The volume option allows you to change the volume of your navigation device or switch it off
entirely. Optionally, you can if necessary also make a separate volume adjustment for
individual functions in the Falk Navigator.
To change the system volume or switch it off entirely, first tap on the Volume button. You
can increase the volume by tapping on the plus symbol or reduce the volume by tapping on
the minus symbol. The volume which is set is indicated to you as a ratio of the maximum
volume.
However, you also have the option of switching off the sound with one click. If you tap on
Sound at the bottom, the sound is muted. When you want to cancel the muting again, click
on Sound again or on the plus or minus symbol.
Confirm your selection with Ok or exit the display with Cancel.
Note: When the battery reaches a low level, the volume is automatically reduced to increase
the operating time.
Under Advanced you can make separate settings in relation to the volume of the speakers
Falk IBEX User Manual 32
To Next Page
Loading...