13 Motore1. General information
USE AND MAINTENANCE MANUAL CHAPTER 1
GENERAL INFORMATIONXEF 250 - Rev01 / 2020
34
1.15 MAINTENANCE INTERVALS
From 7000 km (4200 mi) or 9 months, repeat the maintenance intervals starting from 3000 km (1800 mi) or 3 months.
Items marked with an asterisk (*) should be performed by a FANTIC dealer as they require special tools, data and technical
skills.
Periodic maintenance chart for the emission control system
No. Item Checks and maintenance jobs Initial / 1000
km (600 mi)
or 1 month
3000 km
(1800 mi) or 3
months
5000 km
(3000 mi) or 6
months
1*
Fuel line
– Check fuel hoses for cracks or damage. √√√
– Replace if necessary.
2
Spark plug
– Check condition. √√√
– Adjust gap and clean.
3*
Valve clearance
– Check and adjust valve clearance when
engine is cold.
√√
4*
Air filter element
– Clean with solvent and apply quality
foam air filter oil.
– Replace if necessary.
√√√
5*
Breather system
– Check ventilation hose for cracks or
damage and drain any deposits.
√√√
– Replace. Every 2 years
6*
Fuel injection
– Adjust engine idling speed. √√√
7
Exhaust system
– Check for leakage.
– Tighten if necessary.
– Replace gasket(s) if necessary.
√√√
8
Engine oil
– Change (warm engine before draining). √√√
9
Engine oil filter element
– Replace. √√√
10
Engine oil strainer
– Clean. √√√
General maintenance and lubrication chart
No. Item Checks and maintenance jobs Initial / 1000
km (600 mi)
or 1 month
3000 km
(1800 mi) or 3
months
5000 km
(3000 mi) or 6
months
1
Clutch
– Check operation.
– Adjust or replace cable.
√√√
2*
Cooling system
– Check hoses for cracks of damage.
– Replace if necessary.
√√√
– Replace with ethylene glycol anti-freeze
coolant.
Every 4 years
3*
Spark arrester
– Clean. √
4*
Front brake
– Check operation, fluid level, and for fluid
leakage.
– Replace brake pads if necessary.
√√√
– Replace brake fluid every 1 year. Every 1 year
5*
Rear brake
– Check operation, fluid level, and for fluid
leakage.
– Replace brake pads if necessary.
√√√
– Replace brake fluid every 1 year. Every 1 year
6*
Brake hoses
– Check for cracks or damage and replace
if necessary.
√√
7*
Wheels
– Check runout, spoke tightness and for
damage.
– Tighten spokes if necessary.
Every 30 hours