1. General information
USE AND MAINTENANCE MANUAL CHAPTER 1
GENERAL INFORMATIONXEF 250 - Rev01 / 2020
37
1
No. Item Checks and maintenance jobs
After break-in Every race Every third
race (or 500
km)
Every fifth
race (or 1000
km)
As required
15 *
Generator rotor nut
– Retighten. √√
16 *
Muffler
– Inspect and retighten. √√
– Clean. √
– Replace. √
17 *
Crank
– Inspect and clean. √√
18 *
Throttle body
– Inspect. √
19
Spark plug
– Inspect and clean. √√
– Replace. √
20
Drive chain
– Lubricate and check slack/
alignment.
√√
– Replace. √
21 *
Cooling system
– Check coolant level and leakage. √√
– Check radiator cap operation. √
– Replace coolant. Every two years √
– Inspect hoses. √
22
Outside nuts and bolts
– Retighten. √√
23
Air filter
– Clean and lubricate. √√
– Replace. √
24
Oil filter
– Replace. √√
25 *
Engine guard
– Replace. √
26 *
Frame
– Clean and inspect. √√
27 *
Fuel tank, fuel pump
– Clean and inspect. √√
28 *
Fuel hose
– Inspect. √
– Replace. Every four years √
29 *
Brake(s)
– Adjust lever position and pedal
height.
√√
– Lubricate pivot point. √√
– Check brake disc surface. √√
– Check fluid level and leakage. √√
– Retighten brake disc bolts,
caliper bolts, master cylinder
bolts and union bolts.
√√
– Replace pads. √
– Replace brake fluid. Every one year √
30 *
Front fork(s)
– Inspect and adjust. √√
– Replace oil. √√
– Replace oil seal. √
31 *
Front fork oil seal and
dust seal
– Clean and lubricate. √√
32
Protector guide
– Replace. √
33 *
Rear shock absorber
– Inspect and adjust. √√
– Lubricate. (After rain ride.) √√
– Retighten. √√
34 *
Chain and roller slider
– Inspect. √√
35 *
Drive chain stopper
– Inspect. √
36 *
Swingarm
– Inspect, lube and retighten. √√
37 *
Relay arm, connect- ing
rod
– Inspect, lube and retighten. √√
To Next Page