© 2010 HID Global Corporation All rights reserved
DTC1000/DTC4000 Card Printer/Encoder User Guide (L001398, Revision 1.2)
54
Using the Advanced Settings tab
Setting Option
Flipper Home Offset
This is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated this value may need to be adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
Flipper Lam Height
Offset
This is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated this value may need to be adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
Mag HI-Co Voltage Offset
This option changes the voltage going to the magnetic
head. (Note: This is factory set and should not be
changed unless directed by a technician.)
Mag Lo-Co Voltage
Offset
This option changes the voltage going the magnetic head.
(Note: This is factory set and should not be changed
unless directed by a technician.)
OLED Contrast
(display contrast)
Use this option to increase or decrease the contrast of the
printer OLED (if applicable).
To Next Page
Loading...
