Windows Server Program
ComTec GmbH 4-5
The file WEBMCAA.CFG contains a complete list of commands for setting parameters; an
example is:
range=4096 ; Memory size for spectra
rtpreset=1000 ; Realtimepreset value (seconds)
rtprena=0 ; Realtime preset enable (1=enabled)
ltpreset=1000 ; Lifetime preset value (seconds)
ltprena=0 ; Lifetime preset enable
roipreset=0 ; ROI preset value
roiprena=0 ; ROI preset enable
roimin=0 ; ROI lower limit (inclusive)
roimax=2048 ; ROI upper limit (exclusive)
autoinc=0 ; Enable Auto increment of filename
datname=test2.dat ; Filename
savedata=0 ; Save at Halt
fmt=dat ; Format (ASCII: asc, Binary: dat, GANAAS: spe)
smoothpts=5 ; Number of points to average for a smooth operation
A data header file with extension .MCD contains a subset of above parameters and some
additional information typical for the special measurement. An example is the file Sd0002.MCD:
REPORT-FILE from 11/22/94 13:52:56 written 01/30/96 9:57:55
; the first time is when the measurement was started,
; the 2
nd
when the data file was written
REPORT-FILE from 11/22/94 13:52:56 written 01/30/96 9:57:55
; the first time is when the measurement was started,
; the 2
nd
when the data file was written
REALTIME:
3012.000 ; real time in seconds
LIFETIME:
3000.000 ; life time in seconds
TOTALSUM:
1870706 ; total sum of counts
ROISUM:
1870706 ; sum of counts in ROI
NETTOSUM:
1858424 ; sum in ROI with background subtracted
cmline0= 11/22/94 13:52:56 ; comment lines: the first line always contains the start time
cmline1=2
cmline2=Calibration source
cmline3=Oberhaching
cmline4=1/1/93 12:00:00
cmline5=10
cmline6=mg
To Next Page
Loading...
Need help?
General