Operation
4812158701_G.pdf 2019-10-01
Master switch
1
Fig. Cover, left side
1. Battery disconnector switch
Before leaving the roller for the day, switch the master
switch (1) to the disconnected position and remove the
handle.
Before switching off the battery isolation switch,
wait for at least 30 seconds after the ignition lock
has been switched off, in order to avoid the
engine's electronic control unit (ECU) sustaining
damage.
Before switching off the battery isolation switch,
wait for at least 30 seconds after the ignition lock
has been switched off, in order to avoid the
engine's electronic control unit (ECU) sustaining
damage.
This will prevent battery discharging and will also
make it difficult for unauthorized persons to start and
operate the machine. Also lock the hood to the engine
compartment.
80
To Next Page
Loading...
