How to fix clicking noises in FAZUA Evation drivepack?
To address clicking noises in your FAZUA Bicycle Accessories drivepack, push the polygon coupling back into its original position to mobilize it again. The cause may be that the polygon coupling has been loaded on one side.
What to do if the upper LED on my FAZUA Evation remote is red?
If the upper LED on your FAZUA Bicycle Accessories remote is lighting up or flashing red, it indicates a connection error between the drivepack and the bottom bracket. To resolve this, clean the interface between these two components, as dirt may be obstructing the connection.
Why the remote cannot be switched on in FAZUA Evation?
If the remote for your FAZUA Bicycle Accessories cannot be switched on, first, try turning the battery on using the on/off button. The battery may be empty or switched off due to an extended idle period. Charge the battery if necessary. Also, the interface between the battery and the drivepack may be dirty. Clean the interface between the battery and the drivepack.
Why does the motor power feel lower than usual in FAZUA Bicycle Accessories?
If the motor power of your FAZUA Bicycle Accessories feels lower than usual, it could be due to several reasons. If the drive system is brand new, wait until it is 'retracted,' as it requires a few kilometers to produce full power. Alternatively, very hot or very cold temperatures can limit the performance of the battery.
What does it mean if the upper LED on my FAZUA Evation remote is yellow?
If the upper LED on your FAZUA Bicycle Accessories remote lights up or flashes yellow, there may be a bad connection between the speed sensor and the bottom bracket. Check the position of the spoke magnet.
What to do if there is a sudden lack of support when riding the bike FAZUA Evation Bicycle Accessories?
If you experience a sudden lack of support when riding your bike with FAZUA Bicycle Accessories, it could be due to the BMS protective function. To resolve this, switch off the battery by pressing the on/off button for 3 seconds and then switch it back on again.
What to do if the battery cannot be inserted into the drivepack FAZUA Evation Bicycle Accessories?
If the battery cannot be inserted into the drivepack or snapped into the battery holder of your FAZUA Bicycle Accessories, the interface between the battery and the drivepack may be dirty. Clean the interface between the battery and the drivepack.
Why are the white LEDs on the FAZUA Evation Bicycle Accessories remote flashing?
If the white LEDs on your FAZUA Bicycle Accessories remote flash, it indicates a software update. After a new firmware update, the remote will update itself automatically. Please wait and do not switch off the remote until the LEDs stop flashing.
Defines the intended use of the drive system.
Key safety instructions for using the drive system.
Safety precautions for riding the e-bike in traffic.
Steps for mounting and dismounting system components.
How to adjust the electric assist level.
Guide to using the e-bike's walking/pushing assist feature.
How to correctly position and align the speed sensor and spoke magnet.
Steps to fix misaligned speed sensor or spoke magnet.
Guide to using the e-bike's walking/pushing assist feature.
Instructions for turning the "fX" remote system on and off.
How to adjust pedal support with the "fX" remote.
Procedures for charging the battery.
How to connect the charger to the battery.
General| Motor Power | 250W |
|---|---|
| Battery Capacity | 250 Wh |
| Weight | 4.6 kg (motor and battery combined) |
| Torque | 55 Nm |
| Assist Modes | Breeze, River, Rocket |
| Removable Battery | Yes |
| Nominal Voltage | 36V |
| Battery Weight | 1.4 kg |
| Top Assistance Speed | 25 km/h (EU), 20 mph (US) |
| Connectivity | Bluetooth (via Fazua App) |
| Motor Type | Mid-drive motor |
| Charging Time | 3.5 hours |
| Compatibility | Road, Gravel |
| Display | FAZUA Remote (optional) |
To Next Page
