2. Safety instructions for electric drives and controllers
Festo P.BE-CMMP-FHPP-DN-SW-EN en 0708NH 13
Warning
For switching the control contacts you should use gold-plated
contacts or high-pressure contacts.
Precautionary measures must be taken for preventing
interference to switching systems, e.g. switching protective
switches and relays with RC elements or diodes.
You must observe the safety regulations and directives of the
country in which the device is to be used.
Warning
The environmental conditions specified in the product
documentation must be observed.
Safety-critical applications are not permitted if they are not
explicitly approved of by the manufacturer.
Warning
The technical specifications as well as the connection and
installation conditions for the motor controller can be found in
this product manual. These specifications must be observed at
all times.
Warning
DANGER!
The general installation and safety regulations for working on
high-current systems (e.g. DIN, VDE, EN, IEC or other national
and international regulations) must be observed here.
Failure to observe these regulations can lead to bodily injury, death
or considerable damage to property.
The following precautionary measures also apply without claim to
completeness:
Regulations for setting up high-voltage systems up
to 1000 volts
Electrical equipment for machines
Equipping high-voltage systems with electronic
operating media
To Next Page
Loading...
Need help?
General
