Festo CMMP Series Description

6. Configuration in the DeviceNet network
Festo P.BE-CMMP-FHPP-DN-SW-EN en 0708NH 25
6. Configuration in the DeviceNet network
The way in which you configure your network depends on the configuration software used.
Follow the instructions of the controller manufacturer for registring the EDS file of the
motor controller.

Festo CMMP Series Specifications

General

Control Mode	Position, Torque
Communication Interfaces	CANopen, EtherCAT, PROFINET, Ethernet/IP
Power Supply	24 V DC
Feedback System	Incremental encoder, Absolute encoder
Number of axes	1
Relative humidity	5% to 95% (non-condensing)
Operating temperature	0 °C ... +50 °C