Festo CPX-E-CEC Series - Parameterisation overview; CPX parameterisation aspects; System and CODESYS parameterisation

The following pages are available:
CPX
Terminal
– Module configuration of the automation system CPX-E
– Module addressing of the automation system CPX-E
CI (Communication Interface)
– Execute commands from the CPX-E-CEC
System
– Diagnostics information
– Information about the controller and current parameters
– Information about the controller manufacturer
CODESYS
– Information on the CODESYS licence for the controller
3 Parameterisation
The behaviour of the automation system CPX-E can be set using the following parameters:
– System parameters
– Diagnostic memory parameters
– System bus parameters
You can find a detailed description of the individual parameters in the "Description of the automation
system CPX-E" and in the descriptions of the corresponding modules è 1.1 Applicable documents.
Parameterisation
19Festo — CPX-E-CEC-... — 2018-09