1 Safety and requirements for product use
Festo – P.BE-CPX-FB23-24-EN – 1305a – English 7
1 Safety and requirements for product use
1.1 Safety
1.1.1 General safety instructions
• Observe the general safety instructions in the corresponding chapters.
Specific safety regulations can be found immediately before the task instructions.
Note
Damage to the product from incorrect handling.
• Switch off the supply voltage be fore mounting and installation work. Switch on sup-
ply voltage only when mounting and installation work are completely finished.
• Never unplug or plug in a product when powered!
• Observe the handling specifications for electrostatically sensitive devices.
1.1.2 Intended use
The bus node documented in this description is intended as participant on the fieldbus system Control
& Communication link (CC-Link) Mitsubishi exclusively for use in the Festo CPX terminal for installation
in machines or automated systems and used as follows:
– in excellent technical condition
– in original state without unauthorised modifications with exception of the adaptations described in
this documentation
– within the limits of the product defined by the technical data ( appendix A.1)
Note
In the event of damage c aused by unauthorised manipulation or other than intended
use, the guarantee is invalidated and the manufacturer is not liable for damages.
To Next Page
Loading...
