Festo DGP-8 - Page 25

DGP(L)−...−B
Festo DGP(L)−...−B 0609g English
25
Fitting profile fastenings type MUP−...:
1. Place the DGP(L)−... so that all the operat
ing parts are accessible.
2. Place the profile fastenings on the
DGP(L)−... in accordance with Fig.7.
If the sliding blocks of sizes 32...80 are
tilted, they will slide into the groove at
any point on the profile.
3. Tighten the fastening screws to
an equal
extent.
4. Make sure that the profile fastenings are
outside the positioning range of the slide.
In order to do this, push the slide once over
the entire positioning path.
Fig.7
DGP(L)−32...80
DGP(L)−8...25
Fig.8