FT-70/75 Fill Level Inspectors Operator’s Guide
1-6
Optional System Features
The FT-70/75’s expandability allows you to add additional
inspection capabilities to match your production requirements.
Depending upon the FT-70/75 configuration you ordered, your
unit may contain some of the following features:
• High Cap/Bulged Can Detection
• Missing Cap/ Missing Lid Detection
• Dud Detection (High and Low Container Pressure)
• Smashed Bottle Detection
• Down Container Detection
• Low Foam Detection
• Foil Seal Detection
• Label Inspection
• Reject Sorting (Servotec only)
• External Reject Control
• Serial Controller Interface (Modbus or IDC Protocols)
• Programmable Logic Controller Interface (PLC)
Note
If you are unsure which options your unit contains, contact your
Service Department for information.
High Cap/Bulged Can Detection
This feature utilizes an optical sensor detect improperly seated
caps on bottles or bulged lids on cans.
Missing Cap/Missing Lid Detection
This feature detects the presence or absence of the container cap
(bottle) or lid (can). It is compatible with either plastic or metal
caps and lids.
Dud Detection
This feature detects improper pressurization of vacuum sealed or
pressure sealed containers.
Industrial Dynamics Company, Ltd. Document 40274-0600
To Next Page
Loading...