Filtec FT-75 - The Rejector Arm Is Sticking or Binding; The Rejector Arm Remains Extended; Rejected Container Trajectory Is Sloppy or Inconsistent

FT-70/75 Fill Level Inspectors Operator’s Guide
4-16
The rejector arm is sticking or binding
1. Check the rejector piston for smooth movement.
2. If it is binding, contact your Service Department.
The rejector arm remains extended
1. Is sufficient oil getting to the rejector? Check the oil level in the
oiler (on some models only).
2. Turn the FT-70/75’s power off. If the rejector remains extended,
contact your Service Department.
Rejected container trajectory is sloppy or inconsistent
1. Fatigued or worn pads cause the rejected container's trajectory
to change.
2. Replace rejector pad.
Industrial Dynamics Company, Ltd. Document 40274-0600