Chapter Three: Using the System Software
3-13
Rejector Functions Group
Rejector Status
Disables or enables the reject signal transmitted by the FT-70/75 to
the rejector. This function also effects the External Reject Function
in the same way. Although the actual rejection is disabled all
counters and alarms continue to accumulate.
Fire Rejector On Demand
Fires the rejector manually. This function is used to test the rejector
mechanism or to manually activate it during start-up to provide
initial lubrication under no load.
To execute Fire Rejector On Demand:
1. Press Key 4 until FIRE REJECTOR ON DEMAND appears.
2. Press the Arrow Key to fire the rejector.
Industrial Dynamics Company, Ltd. Document 40274-0600
To Next Page
Loading...