FT-70/75 Fill Level Inspectors Operator’s Guide
2-8
Adjusting Optional Sensors and Sensor Brackets
After you have adjusted the head height and Centerline Trigger
Bracket height you may need to adjust any optional sensors or
sensor brackets that are installed on the FT-70/75. Your Service
Department should indicate whether or not you will need to make
these adjustment and what the adjustment should be.
If your Service Department has not indicated the correct settings
for the sensors, use the procedures in this section to help you
adjust the following sensors:
Bottles
• Missing Cap, page 2-9
• High Cap, page 2-11
• Smashed Bottle, page 2-13
• Down Container, page 2-21
Cans
• Missing Lid, page 2-17
• Bulged Lid, page 2-19
• Down Container, page 2-21
Industrial Dynamics Company, Ltd. Document 40274-0600
To Next Page
Loading...