FT-70/75 Fill Level Inspectors Operator’s Guide
3-4
Software Function Groups
The Function Group Keys are numbered one through six, repre-
senting each of the following function groups:
• Fill Level Function Group (Key 1)
• Finishing Function Group (Key 2)
• Counters Function Group (Key 3)
• Rejector Function Group (Key 4)
• System Function Group (Key 5)
• Diagnostic Function Group (Key 6)
Operator’s access to the FT-70/75’s system software grants you
rights to specific functions required to operate the unit, therefore
you will have limited access to each function group.
The Function Keys
Pressing a function key displays the first available function in that
group. Repeatedly pressing the same function key scrolls through
the list of available functions.
The Arrow Keys
The Arrow Keys allow you to change a parameter value,
enable/disable a function, reset shift counters, or clear an error.
After you select the proper function with a Function Key, press the
Up Arrow to increase a value or press the Down Arrow to decrease
a value. Holding the key down will rapidly increase the value.
After you make a change, press another function key, or wait 5
seconds, and the value is automatically entered into memory.
Industrial Dynamics Company, Ltd. Document 40274-0600
To Next Page
Loading...