19
ESPAÑOL FRANÇAIS
DEUTSCH
ENGLISH
ITALIANO
E= error W= warning
15. ERROR CODE
Below lists the errors that you may encounter and their description:
Codice
Description
E 8101 Invalid data buffer
E 8102 Error while writing data
E 8103 Invalid CAN index/subindex
E 8104 Read-only CAN object
E 8105 Error while reading data
E 8106 Timeout expired while writing data
E 8107 Timeout expired while reading data
E 8108 MMS application not supported
E 8109 Data connection lost
E 8201 SD card not present
E 8202 SD card unformatted
E 8203 Error while reading data from file
E 8206 Missing data file
E 8209 Synergic table missing!
E 820c SD update required!
E 8fa1 Menu creation aborted
E 8fa2 Hyerarchic menu creation aborted
E 8fa3 Parameters creation aborted
E 8fb1 Wrong configuration
W 4701
Gas purge
Warning which appears when the button is pressed purge gas
E 9001
Antisticking
Warning which appears when the output of the machine is short-circuited, MMA or TIG mode
E 9002
Inverter overtemperature
Warning which appears when the protection is hardware temperature of the inverter
E 9003
Power supply error
Warning which appears when the supply voltage exceeds the specified limits or when there are one or
more phases (three-phase machines only)
E 9004
Thermal overload
Warning which appears when the machine has passed the said duty cycle of Use
E 9005
Water low pressure
Signaling that appears when the pressure of the coolant is low, due to lack of the same liquid, presence
of air bubbles or air bubbles in the cooling circuit
E 9006
AC group overtemperature
Warning which appears when the protection is hardware assembly temperature for polarity reversal
E 9010
Torch trigger pressed, release the torch trigger and / or verify proper operation
Warning which appears when turning on the machine, the trigger is depressed
To Next Page
Loading...
