33
LIMING WITH THE HYDROSEEDER
®
(CONTINUED)
15. With the slurry pump clutch still engaged (turned on), re-open discharge valve to commence
application.
To decrease pump wear and increase discharge distance, it may, at
this point be desirable to close the recirculation valve. However, the
recirculation valve must be open BEFORE closing the discharge valve if the application of slurry
is to be interrupted. Extreme heat, which will cause damage and/or bodily injury, will occur if
both valves are closed.
16. Apply the slurry. See APPLICATION OF SLURRY section.
17. If another load is to be applied, start again at step 1. If finished, follow the clean-up procedure.
To Next Page
Loading...
