Finn HydroSeeder T280 - Weekly or Every 40 Hours of Operating Time; Seasonal and Winter Storage Maintenance

35
CLEANING AND MAINTENANCE (CONTINUED)
WEEKLY OR EVERY 40 HOURS OF OPERATING TIME
1. Clean the air cleaner following the instructions in the engine operator’s manual.
2. Lubricate all the points on the HydroSeeder
®
as outlined in DAILY on page 28. Additionally,
lubricate the four grease fittings on the clutch/pump.
3. Check the level in the hydraulic oil reservoir. Maintain level at sight gauge.
4. Check the clutch adjustment to ensure that it snaps in and out of engagement. Adjust the
clutch with the engine off.
5. Check the antifreeze in the radiator.
6. Inspect the slurry tank for buildup of residue in the suction area and clear if necessary.
7. Check and clean engine radiator. Flush with clear low pressure water and blow dry with
compressed air. Do NOT use high pressure water spray.
8. Check pivoting hose reel swivel bolt. Ensure proper torque. Replace bolts if any show signs of
wear.
SEASONAL AND WINTER STORAGE MAINTENANCE
1. Remove drain plug and drain the slurry tank of all water prior to storage. Leave drain plug
removed.
2. If possible, cover machine with tarp or park inside of an enclosure.
3. Store the HydroSeeder
®
with all slurry valve handles in the open position. To prevent damage
from freezing, it is advisable to remove all slurry valves and store in a heated area.
4. Store the HydroSeeder
®
with all slurry valve handles in the open position. To prevent damage
from freezing, it is advisable to remove all slurry valves and store in a heated area.
5. Pour 1 quart (0.95 L) of mineral oil or environmentally safe lubricant into the pump housing
and spin pump by hand to prevent rust in the pump. Remove drain plug.
6. Chip and steel-brush any interior rust spots in the slurry tank and touch up with paint.
See steps 2 and 3 in IV. MAINTENANCE of the HYDROSEEDER® SAFETY SUMMARY
SECTION.
7. Lubricate all fittings.
8. Check antifreeze in radiator.
9. Lubricate equipment again just prior to putting into operation afte having been in storage.
10. Change hydraulic oil and filter. (500 hours)
11. Disconnect battery cables. In cold weather, remove battery and store it in a safe, warm place.
12. Add fuel stabilizer to fuel tank.