– 69 –
7. The system will search for the next zone that does not have a serial
number associated with it. If one is found, the prompt in step 5, along
with the appropriate zone number, will be displayed. Follow steps 5
and 6 for the remaining wireless zones.
After all wireless zones have been displayed, whether enrolled or not, the
"Enter Zn Num." prompt will appear. Enter "00" to exit the Sequential mode
and return to data field programming mode.
When you have finished programming all zones, test each using the
system's TEST mode. Do not use the Transmitter ID Sniffer mode for
this, as it will only check for transmission of one zone on a particular
transmitter, and NOT the zones assigned to each additional loop.
To Next Page
Loading...
