Flashforge Corporation
Dreamer User Guide | www.flashforge.com
2.1.3 Ter ms
The surface on which the Dreamer builds an object.
The blue tape that covers Dreamer’s build plate so that
the object can adhere to the build plate well.
The three dimensional amount of space that an object
will use once it is completed. The largest build volume
of Dreamer is 230*150*140mm.
Knobs under the build platform that are used for
adjusting the distance between the nozzle and build
plate.
The device that draws the filament from the spool,
melts it and pushes it through a nozzle onto the build
plate.
Also called “print head”, which located at the bottom of
the extruder where heated filament is squeezed out.
To cool the outer assembly of the extruder and gear
motor.
An opening located at the top of the extruder .
A plastic piece that guides the filament from the
filament box to the filament intake.
A tool that used for cleaning and unclogging the
extruder.
A tool that used for seizing the nozzle’s metal cube.
To Next Page
Loading...
