Flashforge DREAMER - Chapter 6: About Software; 6.1 Software Installation; 6.1.1 Software Acquisition; 6.1.2 Software Installation and Start-up

Flashforge Corporation
Dreamer User Guide | www.flashforge.com
29
Chapter 6: About Softwar e
This chapter talks about the basic function of FlashPrint. For more information about
advanced function, you can browse our website http://www.FlashForge.com.
6.1 Softwar e Installation
6.1.1 Software Acquisition
Method 1: To get the installation package from the SD Card in the toolkit.
Method 2: Open the link below to download the installation package:
http://www.FlashForge.com
Support---Downloads---FlashPr int---Choose the softwar e ver sion---Download
6.1.2 Software Installation and Start-up
1. Decompress the zipped file or start the installation program, and then install the
software according to the direction.
2. Start the software with the start menu shortcut or by clicking the software icon.(See
6-1)
6-1
6.2 Explor ing FlashPr int
6. 2.1 Machine Type Selection
Note! After starting FlashPrint, you need to select the target machine type first.
When you start FlashPrint, a dialog box will pop up. Just need to select FlashForge
25