Flashforge DREAMER - Page 27

Flashforge Corporation
Dreamer User Guide | www.flashforge.com
28
5-5
friction as the previous step.
5. （5-5）Tap [NEXT] again and repeat the same leveling process.
5-6
6. （5-6）Tap [NEXT]. The nozzle will move to the center of the build plate. Slide the
paper through to make sure there is a slight friction. Slowly adjust all the screws by
the same amount if there is no friction or too much friction.
5-7
7. （5-7）Tap [FINISH] once you have finished this.