Flashforge DREAMER - Page 26

Flashforge Corporation
Dreamer User Guide | www.flashforge.com
27
5-2
2. （5-2）Take out the leveling card.
5-3
3. （ 5-3） Once the extruder and build plate stop moving, slide the piece of paper
continuously back and forth between the nozzle and the build plate. And
simultaneously adjust the knob until the paper causes a slight friction.
5-4
4. （5-4）Tap [NEXT] and wait for the extruder to move to the second position. Slide
the paper back and forth again, and adjust the screw to create the same amount of