Flashforge Corporation
Dreamer User Guide | www.flashforge.com
3.
（
3-3
）
Firmly grasp the two side handles of FlashForge Dreamer. Lift it out of the
box and place it on a stable surface. Then you will see the Tool Box and USB cable
in the shipping box. In the Tool Box, you can find a Carving Knife, a Scr aper , a
bag of Grease, Tweezers and a Scr ew Box, which contains a SD card and some
screws, Wr enches.
3-3
4.（3-4）You can find an accessory box on top of Dreamer, which houses the extruder
set. Remove the box and the foam sheet from the Dreamer, and gently lay the extruder
set on the Dreamer build plate.
Inside the accessory box, you will find a dual-extr uder , a tur bofan baffle, and two
pieces of r emovable side panels.
5.Use scissors to remove ties
To Next Page
Loading...
