Flashforge Inventor - Page 28

Inventor User Guide | www.flashforge.com 0086‐ 0579‐82273989
28
5.
（
5-5
）
Press [NEXT]again and repeat the same leveling technique.
5-6
6. （5-6）Press [NEXT]. The nozzle will move to the center of the build plate . Slide
the paper through to make sure there is a slight friction. Slowly adjust all the screws
by the same amount if there is no friction or too much friction.
5-7
7.
（
5-7
）
Press [FINISH]once you have finished this.
25