Flashforge Inventor - Page 31

Inventor User Guide | www.flashforge.com 0086‐ 0579‐82273989
31
6.2.3 Loading
You can load a model file or Gcode file into your Flashprint by the following six
methods:
Method 1: Click the Load icon on the main interface. Then select the
object file.
Method 2: Select the file for loading and drag the file to the main interface of the
software.
Method 3: Click [File]--[Load File]. Then select the object file for loading.
Method 4: Click [File]--[Examples] to load the example files
Method 5: Click [File]--[Recent Files] to load the files opened recently.
Method 6: Select and drag the target file to the icon of Flashprint.
Note: .STL, .OBJ, .3MF and .FPP, ways to store 3D models, are supported by
Flashprint for editing.
Generating Rilievo
Loading a png, jpg, jpeg, bmp picture file into the FlashPrint. And the following
dialogue box(6-4) will pop up. The setting box includes settings for shape, mode,
maximum thickness, base thickness, bottom thickness,width, height, t op diameter and
bottom diameter.
Shape: including plane , tube, caniste r and lamp.
Mode: including “darker is higher”and “lighter is higher”.
Maximum thickness: Z value of the model
Base thickness: The minimum raft thickness and the default value is 0.5mm
Cut the model into several parts
Print i t directly with your Inventor or export to your USB stick.