Flashforge Inventor - Page 46

Inventor User Guide | www.flashforge.com 0086‐ 0579‐82273989
46
Allows users to redo the most recent edit you have undone to your model file by the
following two methods
Method 1: Click [Edit]--[Redo]
Method 2: Press the shortcut Ctrl+Y.
③Empty Undo-stac k
To clean up the recorded operating steps so as t o release t he memory.
④
Select All
By the following two methods, you could select a ll models in the scene.(Whenmodels
are too small to be seen or out of viewing scope, please click [Center] and [Scale]
buttons to adjust the model.)
Method 1: Click [Edit]--[Select All].
Method 2: Press the shortcut Ctrl+A.
⑤
Duplicate
Select the object and duplicate the object through the following two methods:
Method 1: Click [Edit]--[Duplicate]
Method 2: Press the shortcut Ctrl+D
⑥
Delete
Select the object and delete the object through the following two methods:
Method 1: Click [Edit]--[Delete]
Method 2: Press the shortcut Delete
⑦
Surface to Platform
After selecting the model, you can make the model surface to platform via the fol lowing
operation.
Click [Edit]--[Surface to Platform] into surface to platform mode(6-18)