Flashforge Inventor - Page 51

Inventor User Guide | www.flashforge.com 0086‐ 0579‐82273989
51
button control extruder move, Z axis button control build plate move. Click X-,
extruder will move leftward a specified distance; Click X+, extruder will move a
specified distance rightward. Click Y-, extruder will move forward a specified
distance; Click Y-, extruder will move backward a specified distance. Click Z-, build
plate will move upward a specified distance; Click Z-, build plate will move
downward a specified distance. (Specified distance refers to the move distance you set
in J og Mode.
c. Stop: Click the [stop] button to abort the current movement.d. XYZ coordinate
frame on the right side: Show the current position of extruder/build plate.
e. Make Current Position Zero button: Set t he current position of t he
extruder/build plate as (0, 0, 0). (NOTE: X, Y, and Z boxes are for display purposes .
Changing the value in the boxes will not affect anything.
f. Center X/Y/Z button: Extruder and build platform will back to the zero (0, 0, 0)
you set last time.
g. X/Y Speed and Z Speed: Set the move speed of extruder/ build platform.
● Limit Switch: In order to protect your Inve ntor, three limit switches a re equipped
to control the maximum position, and the three limit switches corresponding to X/Y/Z
axis limit switch. It ha s two status:
a. Not Triggered: If the extruder/build plate don’t move to its maximum, X/Y/Z axis
limit switch is not triggered, and shows “Not Triggered”.
b. Triggered: If the extruder/build plate moves to its maximum, X/Y/Z axis limit
switch is triggered, and shows “Triggered”.
● Stepper Motor Controls: Allows users to control to stepper motor. Click [Enable],
and lock the motor so it does not allow any movement; click [Disable], and unlock
the motor to be controlled manually.
● LED Color: Allows users to change the LED color of Inventor.