Flashforge Inventor - Page 55

Inventor User Guide | www.flashforge.com 0086‐ 0579‐82273989
55
7.1.2 Dual-Extrusion Print
1. Open FlashPrint by double-clicking on the icon.
2. Press [ Load ] and choose an .stl file from hard drive.
3. The object will then be shown on t he scree n.
4. Press [ Load ] and choose another (or the same) file from hard drive.
5. Click on the object and then click on [Extruder], select [ Use left extruder ].
NOTE: one object is turned to green, that indicates it will be print wit the left
extruder.
6. Now the 3D model is ready to
b
e create
d
.
Before introducing the connection methods, let me give you a brief introduction of
Inventor’s interfaces.
Print
Read the print file from
The local memory card
The SD card
Return arrow