Flashforge Inventor - Page 58

Inventor User Guide | www.flashforge.com 0086‐ 0579‐82273989
58
Tool
Tap [Tools] to enter tool options.
Filament: To load/unload the filament.
Level: To adjust the build plate.
Home: To make the X, Y and Z axes
back to the zero point.
Manual: To manually adjust the
positions of X, Y and Z axes.
Setting:To implement relevant function
setups.
Status: The check the real-time status
of the printer.
About: Information about the printer.
Return arrow
Manual adjustment
Y+: The extruder moves to the zero
point, that is, the back of the machine
Y-: The extruder moves to the direction
opposite to the Y+.
X+: The extruder moves to the zero
points, that is, to the right direction
X-: The extruder moves to the direction
opposite to the X+.
Z+: The build plate elevates.
Z-: The build plate desce nds.
Return arrow
Tap [Setting] to enter the setting
interface
Language: To set the display language
TP Adjust: Adjust the touch screen
Factory Reset: Restore factory defaults
Fan on: To turn on/off the fan
WIFI: To turn on/off the Wifi