Inventor User Guide | www.flashforge.com 0086‐ 0579‐82273989
71
d. Space to Model(Z): The gap between the ra ft top and the model’s first layer.
2
）
Pre-extrusion
a . Ena b le Pre-extrusion: Enable the extruder to pre-extrusion until .
b. Space to Model: The maximum distance between t he pre-extruded filament and
model’s first layer.
C.Path Length: The filament length of pre-extrusion.
d. Speed: The printing speed of pre-extrusion.
3
）
Wall
a. Enable Wall: Enable the extruder to print wall during printing. Enabling wall can
prevent the object from stringing or oozing to some extent.
b. Shell Count: To control the printing laps for support shell.
c. Space to Model: The minimum distance between the wall and model.
d. Speed: Speed at which the wall is printer.
Advanced
1
）
Stepper Motor Voltage(Usually keep default)
8‐6
To Next Page
Loading...
