Fleck 7000 - Programming a Meter Immediate Regeneration System; Setting Feed Water Hardness; Extended Programming: Cycle Step Times

1. Feed water hardness (Display Code H)
The feed water hardness setting displays only if the system is set to operate as a Meter Immediate or Meter
Delayed system type.
— Press the Set Up and Set Down buttons to set the amount of feed water hardness (grains/gallon or
degrees). The system automatically calculates treated water capacity based on the feed water hardness
and the system capacity preset in the Master Programming mode.
Example: Range: 4 – 199 US and Metric
— To program 9 grains / gallon (US) or 9 degrees (Metric) [H – 9]
— Press the Set Up and Set Down buttons to adjust this value.
— Press the Extra Cycle button once to Exit Setup Programming Mode or press and hold the Set Up and
Set Down buttons simultaneously for ve (5) seconds to enter the Extended Setup Programming Mode.
Programming a Meter Immediate Regeneration System
Page 11
2. EXTENDED Programming Mode
Regeneration Cycle Step Programming (Display Code 1 – 6)
This Program Step is used to program the Regeneration Cycle step times. The Regeneration Cycle Step
being programmed is displayed in the rst digit of the display. Each display is used to set the duration time in
minutes of that specic step in the Regeneration cycle.
Example:
Cycle Step dF dFFF FLtr
1 10 = Backwash 12 = Fill 10 = Backwash
2 60 = Brine Draw 60 = Brine Making 10 = Rapid Rinse
3 5 = 2nd Backwash 10 = Backwash
 10 = Rapid Rinse 60 = Brine Draw
5 12 = Rell 5 = 2nd Backwash
6 10 = Rapid Rinse