FT-112(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 10 of 170
10 Mbit/s or 100 Mbit/s, full duplex
Generic EDS-file provided
DHCP or manual IP assign over Indface2x PC Software or by keys in
programming mode. Device identity customization
Line, Bus, Star or Tree topology depending on physical media
Switched Ethernet transmission with shielded twisted pair cables and RJ-45
connectors.
Galvanically isolated bus electronics
Up to 4 ms. response delay after read/write commands.
Digital inputs and outputs of the instrument can be programmed independently as
a Remote IO’s of PLC to control them over fieldbus.
Generic ESI-file provided
Line, Tree, Star or Daisy-chain topology depending on physical media
Switched Ethernet transmission with shielded twisted pair cables and RJ-45
connectors.
Galvanically isolated bus electronics
Up to 4 ms. response delay after read/write commands.
Digital inputs and outputs of the instrument can be programmed independently as
a Remote IO’s of PLC to control them over fieldbus.
156 kbit/s – 10 Mbit/s (selectable)
Line with Trunkline, Branch structure and Termination at both Ends.
3 wires shielded twisted pair cable.
Up to 64 stations per network
Galvanically isolated bus electronics
Up to 4 ms. response delay after read/write commands
Digital inputs and outputs of the instrument can be programmed independently as
a Remote IO’s of PLC to control them over fieldbus.
Supports Ethernet POWERLINK V2.0 Communication Profile Specification
version 1.2.0
To Next Page
Loading...