FT-112(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 48 of 170
FLINTEC
HBM
TOLEDO
SYSTEC
SMA
SARTOR
RINSTR
AVERY
BASTER
LM2
Flintec continuous format.
Commonly used by HBM, GSE, PT, Systec,
Rinstrum.
Commonly used by Toledo, Mettler Toledo.
Commonly used by Systec.
Commonly used by USA producers, Cardinal, Rice
Lake etc.
Commonly used by Sartorious.
Commonly used by PT, Rinstrum, HBM, GSE.
Commonly used by Avery E1205.
Commonly used by Baster.
Flintec LM2 (BX1 par.000=6)
Checksum at continuous and BSI formats.
Checksum disable
Checksum enable
Carriage return at continuous formats.
Carriage return disable
Carriage return enable
Line feed at continuous formats.
Line feed disable
Line feed enable
Data output delay at BSI formats; delay between continuous format
data.
ETHERNET TCP/IP
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
Data format of the Ethernet port
NO
CONT
FAST
PRNT
BSI
MBHL
MBLH
Port is disabled
Continuous data output
High speed continuous data output
Printout
BSI format for PC, PLC interface
Modbus TCP High-Low format
Modbus TCP Low-High format
Press key to select output format different than Flintec
continuous data format while the selection is CONT in the
information display. Available functions are shown on the weight
display after pressing key sequentially. Press key after
selecting the data format.
Refer to Appendix 5 for details data structure.
FLINTEC
HBM
TOLEDO
SYSTEC
SMA
SARTOR
RINSTR
AVERY
BASTER
LM2
Flintec continuous format.
Commonly used by HBM, GSE, PT, Systec,
Rinstrum.
Commonly used by Toledo, Mettler Toledo.
Commonly used by Systec.
Commonly used by USA producers, Cardinal, Rice
Lake etc.
Commonly used by Sartorious.
Commonly used by PT, Rinstrum, HBM, GSE.
Commonly used by Avery E1205.
Commonly used by Baster.
Flintec LM2 ( BX1 par.000=6 )