Flintec FT-112 - Page 65

FT-112(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 64 of 170
[
514
ZEROING
:
50%
]
M
Zeroing range with key.
Page 33
NO
2%
3%
20%
50%
:
:
:
:
:
Disable.
± 2%
± 3%
± 20%
± 50%
[
515
AZTRACK
:
0.5d
]
M
Automatic zero tracking.
Page 33
NO
0.3d
0.5d
1d
2d
3d
:
:
:
:
:
:
Disable.
± 0,3d
± 0,5d
± 1d
± 2d
± 3d
[
516
STABLE
:
0.5d
]
M
Stability detection range.
NO
0.3d
0.5d
1d
2d
3d
4d
:
:
:
:
:
:
:
Disable.
± 0,3d
± 0,5d
± 1d
± 2d
± 3d
± 4d
[
517
STBTIME
:
0.7
]
Stability time.
The scale is accepted as a stable to process, If the scale is stable
during this time.
0.1…. 9.9 seconds.
[
518
MIN TARE
:
20
]
Minimum tare for automatic taring
Taring can be done if loading is heavier than MIN TARE.
[
519
MINWEIGT
:
20
]
Minimum weight to produce printout
The printout is produced if the load is heavier than MIN WEIGHT.
[
51A
TILT
:
NO
]
M
Tilt switch to prevent wrong weighing results in mobile scales.
(Digital Input-4)
NO
OPEN
CLOS
:
:
:
Not used.
Normally open contact.
Normally closed contact.
52-
BUILD
]
SCALE BUILD
Press key or key again to enter this menu.
Press key to enter the next sub-block or press key to go
to the next main block.
[
521
UNIT
:
KG
]
M
The scale unit
Select NO, g, kg, t, lb, klb, N or kN.
Page 35
[
522
RANGE
:
SING
]
M
Scale range
SING
2MR
3MR
2MI
3MI
:
:
:
:
:
Single Range
2 x Multi Range
3 x Multi Range
2 x Multi Interval
3 x Multi Interval