6.3.1.5.6 Schedule
The Events Source > Schedule screen is used for setting a trigger interval for notifications, defining
the method for storing a snapshot, recording on the edge, enabling email headers, defining the OSD
text, and setting the alarm schedule.
Figure 76: Events Source > Schedule Screen
To set a trigger interval
Select Enable. By default, Enable is not checked.
Move the Trigger Interval slider from 1 to 3600 seconds. The default setting is 10 seconds.
To define the method to store a snapshot
See instructions in section 6.3.1.5.1.
To record the event on the camera
See instructions in section 6.3.1.5.1.
To enable sending an email notification
See instructions in section 6.3.1.5.1.
To define OSD text
See instructions in section 6.3.1.5.1.
To set the arming schedule
See instructions in section 6.3.1.5.1.
To Next Page
Loading...
