6.3.1.5.7 Tampering
The Events Source > Tampering screen is used for setting the sensitivity of the camera in case of
tampering.
Figure 77: Events Source > Tampering Screen
To enable tamper detection
Select Enable. By default, Enable is not checked.
From the Sensitivity drop-down list, select High, Medium, or Low.
To define the method to store a snapshot
See instructions in section 6.3.1.5.1.
To record the event on the camera
See instructions in section 6.3.1.5.1.
To enable sending an email notification
See instructions in section 6.3.1.5.1.
To define OSD text
See instructions in section 6.3.1.5.1.
To set the arming schedule
See instructions in section 6.3.1.5.1.
To Next Page
Loading...
