User Interface Menus
5
• Centre Spot (cross-hairs): Enable this mode to view the temperature
measurement of the targeted spot in the upper left hand corner of the dis-
play. Use the cross-hairs to target the measurement spot.
Figure 5.12 Selecting the ‘Centre Spot’ mode from the main menu
• IGM™ Moisture mode: Select this mode to view the moisture measure-
ments on the upper left hand corner of the display. The IGM™ mode (Infra-
red Guided Measurement) is best suited for first scanning an area for
temperature measurements and then taking moisture measurements in the
strategic areas identified by the temperature measurements.
Figure 5.13 Selecting the IGM™ Moisture mode from the main menu
• IGM™ Custom mode: Select this mode to view all of the measurement
types on the MR265 that you enable in the Settings menu (see Section
5.8).
#NAS100070; r. AB/77165/77326; en-GB
13
To Next Page
Loading...
