FLIR MR265 - Moisture Measurement Modes Selection

Moisture Measurement Operation
7
Figure 7.7 IGM™ Custom mode with Moisture and IR Temperature readings on upper left
7.4 Moisture Measurement Modes
Press the Select
button to open the Main Menu, choose the ‘Moisture’
mode
, and then select from the four Moisture mode options as de-
scribed below.
• Material Groups
Select a Material Group that best matches the material under test. This ap-
plies only for external pin-based probe use. Use the menu to make a selec-
tion (Moisture Mode/Material
). Use the Navigation arrows to scroll
through the Material list and press Select
to choose the Group number.
See the Material Group tables in Section 13 Appendices, these tables will
help you decide which Material Group to select.
Figure 7.8 Selecting a Material Group in the ‘Moisture’ menu
• Pin Mode
#NAS100070; r. AB/77165/77326; en-GB
30