User Interface Menus
5
Figure 5.19 Selecting the MR12 (optional moisture probe) mode
• Set Reference mode: This utility is only available when using the built-in
pinless sensor (rear of MR265) or the remote MR12 Ball Moisture probe.
After selecting the pinless mode (or the MR12 mode) and while taking a
moisture measurement, select the ‘Set Reference’ utility to zero the current
measurement value (the delta symbol will appear to inform you that the Set
Reference mode is active). Now, subsequent moisture measurements can
be made relative to the original ‘Set Reference’ value. To release the Set
Reference utility, select the pin mode. See Section 7.8 Set Reference
Mode for additional information.
Figure 5.20 Selecting the reference value in which to compare subsequent
measurements
5.7 Colour Menu
The colour menu allows you to select from five display palettes. Iron, Rainbow,
White hot, Black hot, and Arctic.
#NAS100070; r. AB/77165/77326; en-GB
16
To Next Page
Loading...
