Capturing and Working with
Images
9
9.1 Capturing Images
To capture a screen image, press the Camera button (shown above). The dis-
play will briefly show the filename assigned to the captured image at the top
of the screen. Screen images can be captured for any Image mode: Thermal
MSX®, Thermal, Digital Camera, and Moisture mode. If the internal memory
is full, an error will display and images cannot be captured until room is made
available in the internal storage drive. Images cannot be captured if the
MR265 is connected to a device via USB.
9.2 Viewing Images on the MR265
Press the Image Gallery button (shown above) to open the Image Gallery.
Use the navigation arrow buttons to scroll through the thumbnails and press
Select
to open and enlarge an image. Press Select at an opened image to
view the filename, and press again to see image options (delete, information)
as explained below.
9.3 Deleting images
At an opened image, press Select
twice to see the delete and information
icons. Scroll to the ‘delete’ icon (trash can) and press Select
to erase the
image. Images can also be deleted in bulk by formatting the storage memory
in the Settings menu (Settings/Device Settings/Reset Options). Images can
also be deleted or moved by connecting the MR265 to a PC, see the next
section.
9.4 Image Information
At an opened image, press Select
twice to see the delete and information
icons. Scroll to the Information icon (‘i’) and press Select
to view the image
information.
9.5 Transferring Images via PC Interface
Connect the MR265 to a Windows™ or Apple™ computer’s USB port using
the supplied USB cable. The USB socket is located on the bottom of the
MR265, under the protective flap. Once connected, the MR265 can be used
#NAS100070; r. AB/77165/77326; en-GB
41
To Next Page
Loading...
