FLIR MR265 - Page 21

User Interface Menus
5
• Pin mode: Select this mode when using an external pin probe. See Sec-
tion 7.6 External Pin Probe Measurements for more information.
Figure 5.17 Selecting pin-based measurement mode
• Pinless mode: Select this mode when using the pinless sensor (rear of
MR265). See Section 7.5 Pinless Moisture Measurements for more
information.
Figure 5.18 Selecting the pinless measurement mode
• MR12 mode: Select this mode when using the optional MR12 Ball Mois-
ture probe accessory. The MR12 attaches to the socket on the bottom of
the MR265. See Section 7.7 MR12 Ball Moisture Probe for more
information.
#NAS100070; r. AB/77165/77326; en-GB
15