STRADA PAL – MAINTENANCE MANUAL
86/149
8.3.10 Replacing the escrow
8.3.10.1 Preliminary operations
A. Open the maintenance door
B. Turn off the terminal
8.3.10.2 Replacement
A. Remove the coin selector
B. Unplug the escow (1) cable.
C. Remove the 2 clamping screws (2) at the front of the escrow.
D. Lift the escrow to remove the grips located at its back and remove the terminal.
8.3.10.3 Installation
A. Repeat the previous steps in reverse.
8.3.10.4 End of procedure
A. Turn on the terminal
B. Close the maintenance door Run a coin payment test, then cancel it.
If the door does not close or if the coin is not aligned with the selector, adjust the position
of the escrow by loosening the 2 screws.
To Next Page
Loading...