Fluke 1586A - Initial Setup and Configuration

2-1
Chapter 2
Initial Setup and Configuration
Title Page
Introduction ........................................................................................................ 2-3
Set the Regional Voltage ................................................................................... 2-3
Connect to Mains Power .................................................................................... 2-4
Set the Handle Position ...................................................................................... 2-5
Power On and Standby ...................................................................................... 2-6
Warm-Up the Product ........................................................................................ 2-7
Configure the Product ........................................................................................ 2-7
Input Module and Relay Card Installation ......................................................... 2-8
Install a DAQ-STAQ Multiplexer Connection Module ..................................... 2-11
Set Up Security .................................................................................................. 2-13