Fluke 1586A - Page 81

Input and Channel Configuration
Probe Library 3
3-35
5. Push  to input a new probe.
6. Select Label and push  to set a custom label or push  to read the label from
the channel.
7. Select Function and push  to change. Use the on-screen options to configure the
probe.
8. After the function and label is set, push  to save.
To edit a probe:
1. Push
.
2. Push  or  to highlight a channel then push .
3. Push  or  to select Function then push .
4. Push  to open the Probe Library.
5. Push  or  to highlight a probe in the list then push  to edit.
6. Select Label and push  to change the label.
7. Select Function and push  to change. Use the on-screen options to configure the
probe.
8. After the function and label is set, push  to save the changes.
Assign a probe to a channel:
1. Push
.
2. Push  or  to highlight a channel then push .
3. Push  or  to select Function then push .
4. Push  to open the Probe Library.
5. Push  or  to highlight a probe in the list then push  to assign it to the
channel shown.