Fluke 1735 - Power; Measurement

Power Logger
Measuring Functions
29
Analyzing the measured values of the recorder function:
Use of the key cursor. When you invoke the cursors you can probe the graphs
and display the associated values. With 21 you can select the individual
phases again.
Note
The Cursor functions are only available in the “Hold” mode.
These values can be recorded in the instrument, downloaded and evaluated
with Fluke Power Log software package.
Power
Select Power with the rotary switch.
In this measuring mode you can get the following values for each phase (A, B,
C):
• Power (P) in W (for each phase and its sum P
tot
).
• Reactive power (Q) in var (for each phase and its sum Q
tot
).
• Apparent power (S) in VA (for each phase and its sum S
tot
).
• Distortion power (D) in VA (for each phase and its sum D
tot
).
• Power factor (PF) and the average PF for the three phases.
• Cos ϕ and the average cosϕ for each of the three phases.
• Active energy (EP) in kWh.
• Reactive energy (EQ) in kVAR.
Measurement
You can determine the instantaneous values and store them. You can also
record the values with the recorder function.
If you select this measurement mode you will get the following display: