1735
Users Manual
16
Instrument Setup
In this menu option you can make adjustments in the submenu for:
• Current Probes
• Voltage Transformers
• Phase Identification
• Backlight
• Version and Calibration
These are described individually in the following:
Current Probes
When a Flexi set or Current Probe is connected to the instrument it is
automatically recognized, but only at power-up. Select the current measuring
range by pressing B. If the secondary of a current transformer is being
measured, it is possible to display the current in terms of the primary by
entering a CT ratio into the current probe setting.
edx013.bmp
Use 21 to select transformer ratio
Use 4 5 to enter the ratio
To Next Page
Loading...
