Fluke 190 Series II - Chapter 6 Tips; Using the Standard Accessories

Using Memory and PC
Saving and Recalling
5
73
Saving Screens with Associated Setups
To save for example a screen+setup in Scope mode, do
the following:
1
SAVE
Display the SAVE key labels.
From this point the screen is frozen.
2
F1
Open the SAVE menu.
Observe the number of available
and used memory locations.
In METER mode the SAVE AS menu
will be shown now as only a
setup+screen can be saved, see
step 4.
3
F1
Select the target memory INT
(internal memory) or USB (USB
device).
Observe the new SAVE menu if you
select USB.
4
ENTER
Select Screen+Setup and open
the SAVE AS menu.
Below Save As: the default name +
serial number and OK SAVE are
already selected.
To modify the name for this
particular Screen+Setup or to
modify the default name see below
‘Editing Names’.
5
ENTER
Save the Screen+setup.
To resume your measurements press
HOLD
RUN
.